#IAR ARM R5 FUNCALL HOW TO#
#IAR ARM R5 FUNCALL DRIVER#

For more information about the setup of J-Link RDI, please refer to UM08001. Choose Configure in the RDI menu to configure J-Link RDI.Now an extra menu, RDI, has been added to the menu bar.

#IAR ARM R5 FUNCALL DRIVER#

Select the manufacturer driver by navigating to the J-Link software installation directory, and select JLinkRDI.dll, then click OK.Select RDI in the list on the left site.Select 'RDI' in the Driver drop-down menu.In order to use J-Link RDI, the debug driver needs to be changed. Since IAR EWARM V5.30 J-Link is fully and natively supported by EWARM, so RDI is no longer needed. There is one settings file per build configuration for the project. Settings file with default settings is created on first start of a debug session. In the sample below, Start_STM32F103_MB672_Debug.JLinkScript would be correct. Rename the J-Link script to _.JLinkScript.Copy the J-Link script file to folder where the J-Link settings file is located (see section 'J-Link settings file' below).IAR EWARM does not provide any native support for J-Link script files so usage of them cannot be configured from within the GUI of the IDE itself.ДЄnyhow, it is possible to use a J-Link script file by making use of the auto-search feature of the DLL: Select Debugger in the list on the left site.Make sure appropriate target device is specified ( Specifying the target device).Select the appropriate target interface in the Interface box.

Configure a proper target interface speed (fixed 4000 kHz is suitable for most targets and leads to good performance).

Go to Debugger -> Setup and select J-Link/J-Trace in the Driver drop-down menu.

ddf files, please refer to the IAR documentation. If the target device used is not listed in EWARM, either a IAR device description file (.ddf) or the IDE independent way can be used.ДЇor further information regarding.

Make sure that the proper device is selected.

#IAR ARM R5 FUNCALL HOW TO#

In the following, it is explained how to configure a project to be used with J-Link.

7 Connecting to J-Link via J-Link Remote Server.

1 Using J-Link with an existing project.

Iar arm r5 funcall